www.atcom.cn 5
Chapter 2 Software Installation
Test
Environment:
Elastix 1.6
AX- 4S
1. NT mode : set Jumper cap to the left ,set the switch to the left.
TE mode : set Jumper cap to the right,set the switch to the right.
Set the TE/NT mode of the four ports.
After inserting the card into your PCI slot and boot your server, please use the “ lspci ”
command to check the PCI bus compatibility.
[root@elastix ~]# lspci
The correct output will like the following:
==================================================================
04:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5751 Gigabit Ethernet
PCI Express (rev 01)
05:02.0 ISDN controller: Cologne Chip Designs GmbH ISDN network Controller [HFC-4S]
(rev 01)
05:07.0 VGA compatible controller: XGI Technology Inc. (eXtreme Graphics Innovation)
Volari
Z7/Z9/Z9s
==================================================================
An Cologne Chip Designs GmbH ISDN network Controller will be found, if you can not see i t ,
please poweroff your server and try another PCI slot, if
it
still does not help, you have to
check the compatibility issue between the card and your PCI bus.
2. Install complier and update the rpms
in
your system:
[root@elastix ~]# yum install gcc
[root@elastix ~]# yum update
3. Download the mISDN and mISDNuser, then install them:
[root@elastix ~]# wget http://www.misdn.org/downloads/releases/mISDN-1_1_9.1.tar.gz
[root@elastix ~]# wget http://www.misdn.org/downloads/releases/mISDN user -1_1_9.1.tar.gz
[root@elastix ~]#
tar
mISDN-1_1_9.1
[root@elastix ~]# cd mISDN-1_1_9.1
[root@elastix mISDN-1_1_9.1]# make clean
[root@elastix mISDN-1_1_9.1]# make install
[root@elastix mISDN-1_1_9.1]# cd ..
[root@elastix ~]#
tar
-xzvf mISDNuser-1_1_9.1.tar.gz
[root@elastix ~]# cd mISDNuser-1_1_9.1
[root@elastix mISDNuser-1_1_9.1]# make clean
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales